Start a new topic

Cable connection to rotary encoder for DDX320 v2?

Cable connection to rotary encoder for DDX320 v2?

Hi!
I just received your kit today. Looking good!!
It would be very nice if you could post a picture of recommended wiring so that no mistakes or retries are done.

Thanks a lot for helping!

Regards,
Tom :-)
Hi, CN2/4 are both ok, and no damage will happen when you connect it in wrong way, just not work normal. Pls try to connect it without the cable twisting, it will be ok then.
Could you please confirm how the cable between the DDX320 display daughterboard and the rotary encoder daughterboard should be installed? Does it make a difference if it's attached to CN2 or CN4 on the rotary encoder? Which pin on the rotary encoder board should attach to R5 on the display board?



Thank you!
Login or Signup to post a comment